PUERTOS
10 Puertos 10/100/1000 Mbps con 02 Puertos Combo SFP


ESTÁNDARES


Cumple con las siguientes normas:
IEEE 802.3
IEEE 802.3u
IEEE802.3ab
IEEE 802.3z
Soporta operación Half/Full-Duplex
Auto-negotiation
Soporta Auto MDI-X/MDI-II
Soporta control de flujo de IEEE 802.3x


POE Según estándar: IEEE802.3af (802.3at)

CAPACIDAD PUERTOS POE
Puertos 1 a 8 : 15.4 W o 30 W
Max. 30 W en 2 puertos 10/100/1000 Mbps
Max. 15.4 W en 4 puertos 10/100/1000 Mbps
Max. 7.5 W en 8 puertos 10/100/1000 Mbps


POE POWER BUDGET Max. 78 Watts

SFP TRANSCEIVERS SOPORTADOS


DEM-310GT (1000Base-LX, Single-mode, 10km)
DEM-311GT (1000Base-SX, Mutli-mode, 550m)
DEM-312GT2 (1000Base-SX, Multi-mode, 2km)
DEM-314GT (1000BASE-LH, Single-mode, 50km)
DEM-315GT (1000BASE-ZX, Single-mode, 80km)
DEM-210 (Single Mode 100BASE-FX)
DEM-211 (Multi Mode 100BASE-FX)


WDM TRANSCEIVERS SOPORTADOS
DEM-330T/R (Gigabit WDM transceiver, Single-Mode 10km)
DEM-331T/R (Gigabit WDM transceiver, Single-Mode 40km)
DEM-220T (100Base-FX WDM transceiver, Single-mode, 20km)
DEM-220R (100Base-FX WDM transceiver, Single-mode, 20km)


DDRII PARA CPU 64 MB

FLASH MEMORY
16 MB


WIRE SPEED ON ALL FE/GE PORTS
Wire-speed (full-duplex) operation on all FE/GE ports


FORWARDING MODE


Store and Forward


SWITCHING CAPACITY
20 Gbps


MAX FORWARDING RATE 14.88 Mpps

PRIORITY QUEUES
Prioridad 04 colas por Puerto


PACKET BUFFER MEMORY 512 KB

FUNCIONES LAYER 2
MAC Address:

8K Tabla de direcciones MAC
Soporta 256 MAC estáticas
Control de flujo:

Full duplex:802.3x
Full duplex: Back Pressure
Head-of-line blocking prevention
IGMP Snooping:

Soporta IGMP v1,v2
Soporta 256 IGMP snooping groups
Soporta por lo menos 64 static multicast address
IGMP Por VLAN
Soporta IGMP snooping querier (simple querier)
Spanning Tree:

802.1D STP
802.1w RSTP
Loopback Detection:

Desactiva el puerto automáticamente cuando detecta un loop.
802.3ad Link Aggregation:

Soporta máximo 8 grupos por dispositivo y 08 puertos por grupo.
Port Mirroring:

Mirroring support following mode:
Uno a uno
Varios a un puerto
Soporta Mirroring por Tx/Rx/Both
Diagnóstico de cable
Force MDI / MDIX:

Selecciona el estado MDI / MDIX del puerto
Power Saving:

Enabled by default.
Power saving by Link status
Power saving by cable length detection
Activated at 1000 Mbps
Jumbo frame: Hasta 10.000 Bytes

VLAN
Estándar 802.1Q
VLAN Group:

256 grupos de VLAN en total, Max 256 Grupos VLAN estáticos
VID Configurable de 1~4094
Management VLAN:

Soporta 01 VLAN de administración
Auto Voice VLAN:

Maximum user defined OUI is 10
Maximum default OUI is 8
Asymmetric VLAN

Auto Surveillance VLAN

MULTICAST FILTERING
Soporta los siguientes modos (L2):

Forwards all unregistered groups
Filters all unregistered groups

LLDP
Enable or disable


LLDP MED



TIME-BASED POE
Soporte de PoE (on/off) basado en tiempo


ACL (ACCESS CONTROL LIST)
Máximo número de Máscaras/Perfiles

Máximo 50 Perfiles
Soporta 240 reglas compartidas por todos los perfiles
ACL Policy Soporta los siguientes contenidos de paquetes en la política de lista de acceso:

MAC address
IPv4 address (ICMP/IGMP/TCP/UDP)
Acciones ACL: Permitir o Denegar

QOS (QUALITY OF SERVICE)
Número de Colas de Prioridad: 04

Class 0 is Low queue
Class 1 is Middle queue
Class 2 is High queue
Class 3 is Highest queue
Soporta 802.1p:
Cuatro colas de salida
Soporta modo WRR en el manejo de colas
Cuatro clases de mapeo para valor de 802.1p:

Class 0: 1,2
Class 1: 0,3
Class 2: 4,5
Class 3: 6,7
Manejo de colas:

Strict
Weighted Round Robin (WRR)
Bandwidth Control

Soporta control ancho de banda basado en puerto
Minimum granularity for 10/100Mbps ports: 64Kb/s
Minimum granularity for 10/100/1000Mbps ports: 1850Kb/s
Ingress / Egress bandwidth control
Class of Service:

802.1p priority
DSCP

SEGURIDAD
802.1X Port-based Access Control:

Default 802.1X forwarding
D-Link Safeguard Engine:

Protects CPU from Broadcast / Multicast / Unicast flooding
Port Security:

Soporta 64 direcciones MAC por puerto
Broadcast Storm Control:

Permite especificar umbrales en Kbps para todos los puertos.
Permite la detección de broadcast/multicast y tráfico desconocido unicast.
Min granularity : 64Kbps
Mac Estática:

Puede elegir entre Dynamic Forwarding Table (el máximo es
8K)
Puede ingresar manualmente MAC estáticas
Puede desactivar el auto learning
Soporta 256 entradas de MAC estáticas o superior
Only allows the packets with SA matched configured static Macs
DHCP Server Screening
Arp spoofing Prevention:

Entrada máxima 64
SSL:

Soporta v1/v2/v3
Soporta protocolos IPv4

ADMINISTRACIÓN
Web-based GUI:
Compatible con los siguientes navegadores:

IE6/7 or later version
Netscape 8 or later version
Mozilla
Firefox 1.5/2.0 or later version
Soporta IPv4
CLI:
Soporta D-Link-like CLI
Soporta comandos simples incluyendo las siguientes funciones:

Ping: Sends Echo message
Show Switch: Displays the device information
Save: Saves the device’s configurations
Configures IP Address
Shows IP interface
Upload & Download: Firmware or Configuration upgrade
over TFTP
Reset Config: Resets the device to factory default
Reboot: Power cycles the device
Logout: Logs out from current session
Password: Changes the user’s password
Telnet Server: Máximo 04 conexiones, soporte IPv4
TFTP client: soporta IPv4
LLDP Pass-Through
Configurable Auto MDI/MDIX:

Selects the MDI/MDIX status of port
SNMP:

Soporta v1/v2c/v3
SNMP Trap: Soporta los siguientes eventos:

Link state change
STP state change
SNMP authentication failure
System device boot up
Firmware upgrade state
PoE Power On/Off/Error
Over max power budget
SmartConsole Utility can receive the following trap events:

Link state change
STP state change
Illegal Web/CLI Login
System device boot up
Firmware upgrade state
PoE Power On/Off/Error
Over max power budget
System Log:

Max Log Entries is 500
Supports IPv4 log server
BootP/DHCP Client
Time Setting: SNTP
User Account: Maximum connection is 4
Trusted Host: Trusted host number is 10
Configuration File Upload/Download: Via HTTP/TFTP
Firmware File Backup/Upgrade: Via HTTP/TFTP
Save Configuration Added in tool bar
Save Log Added in tool bar
Reset Switch: Will reset all settings except IP address
Reset System: Switch will be reset to its factory defaults and then reboot
Reboot Device: System reboot
Smart Wizard: Pop up setting page only at first time user login
DHCP Auto-Configuration
Debug Command: Soporta “Show Tech Support”


OTHER
Help Navigation Tab:

Online help
Links to local support web site
Downloads User Guide
IP por defecto: 10.90.90.90

Multi-language GUI: English, French, German, Spanish, Italian, Russian, Japanese, Traditional Chinese, Simplified Chinese, Portuguese.

MIB SOPORTADAS
MIB II
Bridge MIB
SNMPv2 MIB
MIB Traps Convention
Interface Group MIB
Private MIB
POWER-ETHERNET-MIB
LLDP-MIB


PROTOCOLOS SOPORTADOS
RFC 768 UDP
RFC 791 IP
RFC 792 ICMP
RFC 793 TCP
RFC 826 ARP
RFC 854 Telnet Server
RFC 855 Telnet Server
RFC 856 Telnet Binary Transmission
RFC 858 Telnet Server
RFC 896 Congestion Control in TCP/IP Network
RFC 903 Reverse Address Resolution Protocol
RFC 951 BootP Client
RFC 1155 MIB
RFC 1157 SNMP v1
RFC 1191 Path MTU Discovery
RFC 1212 Concise MIB Definition
RFC 1213 MIB II, IF MIB
RFC 1215 Traps for use with the SNMP
RFC 1239 Standard MIB
RFC 1350 TFTP
RFC 1493 Bridge MIB
RFC 1519 CIDR
RFC 1945 HTTP/1.0
RFC 2131 DHCP
RFC 2132 DHCP Options and BOOTP Vendor Extensions
RFC 2138 Radius Authentication
RFC 2233 Interface MIB
RFC 2578 Structure of Management Information
Version 2 (SMIv2)
RFC 2647 802.1p
RFC 3416 SNMP
RFC 3417 SNMP
RFC 3621 Power Ethernet


CARACTERÍSTICAS FÍSICAS

INDICADORES DE LEDS
Power
Fan Err(option)
Link/Act/Speed


FUENTE DE ALIMENTACIÓN
Internal universal power supply
AC Input: 0.62A@115V,0.32A@230V


LED’S
Por Dispositivo:

Power
Puerto 10/100/1000 Mbps:

Link
Act
Speed
Puerto SFP:

Link
Act
PoE:

Power feeding
Error condition
No Power feeding

CONSUMO
Máximo: 109.6 Watts (PoE on), 14.45 Watts (PoE off)
Stanby: 7.0W/110V, 7.8W/240V


DISIPACIÓN DE CALOR
373.96 BTU/hr


MTBF
205.249 Hrs


ACÚSTICO
0 dB (A)


NÚMERO DE VENTILADORES
0


BOTÓN DE RESET
Panel frontal


DIMENSIONES
330 x 180 x 44 mm


TEMPERATURA DE OPERACIÓN
0 ~ 40°C


TEMPERATURA DE ALMACENAJE
-10 ~ 70°C


HUMEDAD
Operación: 10%-95% RH
Almacenaje: 5% ~ 95% RH


PESO
1.84 kg


CERTIFICACIONES (EMI)
CE Report
FCC Report
C-Tick Report
VCCI Report
IC Report
MIC Report
Anatel
BSMI
CCC


SAFETY
CE LVD Report
UL/cUL Listed Mark
CSA International Mark
CB Report
Other Requirements

 

Si usted encontró algo ambiguo, incorrecto o incompleto en esta descripción de producto háganoslo saber para poder mejorarla. Le responderemos sus preguntas a la mayor brevedad vía correo electrónico.